Additional information
Origin | Mainland China |
---|
63.00 $
2000 in stock
Origin | Mainland China |
---|
modname=ckeditor
Type1: 2P2 single lamp radio board all parts
Type2: 2P2 single light board all parts + transparent case
2P2 tube single lamp radio board kit, the magnetic rod coil needs to be wound by yourself!
Adapt to 2P3 chassis. Without case! The case needs to be photographed separately. It also does not contain batteries and speakers cannot be carried.
Important note: If the single tube machine is not connected to the antenna or the power amplifier, the sound is too low! Very impractical!
For a small power amplifier, you can use a Bluetooth speaker with an input cable on a mobile phone or a small computer speaker.
And it can only receive a few strong stations, so this kit is only suitable for DIY enthusiasts.
After the completion, the effect of carrying and listening can not be achieved! Free MP3 headset and 3.5 to 6.5 seats.
Introduction to the kit:
The potentiometer is also a switch and regenerative regulation.
DC battery 14500 lithium battery 3.7V and 9V power supply, the screen voltage is 9V. The screen current is less than 0.5mA.
Filament 2.4 volts power supply: 7 feet are positive, 1 feet are negative, 5 feet are empty. Filament current 30mA.
The low base of the lamp emits red LED 2.4V power supply, current-limiting resistance 150 ohms. LED current 16mA.
After the transformer impedance is transformed, you can listen to it with low-impedance 8-32 ohm headphones.
You can use high-impedance 2000-4000 ohm headphones to listen without the transformer.
Refer to the finished product drawing:
Matching circuit diagram:
The kit is shown in the picture, and the coil should be wound by itself. Primary 3–4 about 85 turns, regeneration 5–6 about 10-30 turns
Excluding chassis, batteries and speakers! The single-tube machine also cannot bring the horn. The 2P3 shell is more expensive and needs to be purchased separately!
Weld the 7-pin tube socket first to ensure that the bottom surface of the tube socket is close to the small plate and is flush. After welding, cut off the protruding welding feet.
When soldering the LED, pay attention to the height when soldering, and the top surface should be flush with the top of the tube socket to have a better luminous decoration effect.
Finally, solder the current-limiting resistor and cut the leads short. At this time, solder the pads on the resistor surface.
First, weld the potentiometer plate vertically to the main board, and then weld the potentiometer.
The variable capacitor should be welded after welding and adjusting the small plate of the tube socket.
The electron tube should be inserted into the soldered small board first, and tied with a cable tie to be flush with the board.
After the small board of the lamp holder is perpendicular to the main board, the 7-pin header is soldered.
The semi-circular pad on the back of the board, short-circuit and non-short-circuit are used to select access or non-access,
1. The antenna can be connected to only one antenna and 10 turns on the magnetic rod for grounding.
2. The 223P included in the variable capacitor kit needs to be short-circuited with the variable foot pads to make the two sets in parallel.
3. Use the transformer to solder only 4, 2 pads on a wire, the middle of the welding is connected to 8 ohms, and the welding side is connected to 32 ohms.
Use the high-resistance headphone transformer to connect the 5 pads without shorting, and connect the high-resistance solder joints and the headphone socket directly with a wire.
4. The headphone socket is inserted into a 2-pin 3.5 to 6.5 high-impedance conversion plug,
It is necessary to cut the solder joints of the lower sound channel to avoid short-circuiting the sound signal.
2.1A Dual USB Chargers 2 Ports Fast Charging Auto Mobile Phone Chargers Socket Adapter Power Outlet Feature: 1. Built-in microcomputer current identification system, which can automatically distribute current according to charging equipment, with functions such as overheating, overcurrent, overvoltage, short circuit, current limiting, etc., to provide effective protection for the equipment. 2. Special craftsmanship, fine workmanship The all-metal shell, wear-resistant, high gloss, seamless integrated design, blends with your car, perfectly matched, highlighting high-end and noble. 3. Super dazzling blue light indicator The beautiful blue LED indicator light is stylish and beautiful. It not only clearly [...]
40.63 $ Add to cartDescription: White color Material: ABS + metal Product material: ABS shell, solid copper Connector: universal jack design, support plug access in 153 countries Electrical rating: AC 250V 10A 800W Scope of application: small power appliances such as mobile phones important hint: The total power of 1 connected appliance should be below 800W not overloaded Specifications: Feature: 100 new high quality Great for travel Small and light Very convenient to use, to meet all your needs When you travel in Europe, you can use this adapter with equipment/equipment from the US, Canada, UK, Europe, Australia, Asia... or other countries [...]
40.39 $ Add to cartsupport dropshipping, box pack,Free shipping We have enough stock to ship within 3 days of ordering! Features:Premium Performance: USB output with total current 5V/1A and input with 100-240V enables you to charge mobile devices simultaneously at high speed.It can really save your time.Safety assurance: USB Wall Charger has protection system against over charging, over currents, and over heating. The charger will automatically stop charging when power is full, which can maximumly protect your charger adapter allows charging at home or in the office via USB cable connection. Simply plug in the USB cable, and plug the adapter into [...]
40.60 $ Add to cartBullet Points:1、【Fast Wireless Charging】 : Our Wireless Charger is only compatible with other QI-enabled devices that will charge at standard wireless charging Shell】: Our Metal Wireless Charger can transmit power through most protective shells rubber/TPU shells up to 5 mm thick only. So come to use our product now!3、【Use Safety】: Our Wireless Charger Pad has a Qi-certified intelligent protection technology, which includes over temperature, over pressure, over current protection, and foreign body Protection】: Our Wireless Charger Pad with a non-slip rubber base that prevents your device from sliding during charging. So come to use our Body】: Our [...]
42.55 $ Add to cart1PC Cute Data Line Protector Cartoon Cable Winde Soft Silicone USB Wire Cord Protectors Charging Cable Cover Winder Organizer Cable Winder Clip For Mouse Phones Cable holder Ties Charging Cable Protector For USB Charger Cord management cable organizer Description: x Cartoon small animal data line protective cover, protect data cable or earphone cable tail, prolong service life. x The product material is crystal drop glue, crystal clear, bright color, very good-looking. x Cartoon animal modeling, widely used, can be used for photo album, mobile phone and other decoration. Specifications: Winder type: cartoon Winder style: cartoon [...]
40.31 $ Add to cartDescription: 100 brand new This cable tie anti-lost design can be fixed on the line body. Tied up when needed, it can prevent loss and can be used for binding. Environmentally friendly materials feel good and can be used repeatedly! You can organize your wire very well to make it look more beautiful Product Name: Finishing buckle Material: Silicone Size: length 74 x width 10 x strap thickness 1.5 Specifications: This cable tie anti-lost design can be fixed on the line body. Tied up when needed, it can prevent loss and can be [...]
40.51 $ Add to cartA2DP Bluetooth-compatible V5.0 Music Receiver Adapter 30 Pin Dock Connector For IPad IPod IPhone Apple Speaker 30 Pin Receiver Description: Support Bluetooth 5.1 protocol specification Support Lingo protocol and device authentication Support automatic identification of certified and non-certified base audio Transmission distance: not less than 10 meters Interface: standard iPod 30pin interface Dimensions: 44 x 36 x 7mm 2 indicator lights flash alternately when there is no connection, and the blue light flashes slowly after connection Specifications: Product Instructions for Use. Equipment identification: I-WAVE 1. Turn on the speaker, plug the product [...]
45.16 $ Add to cartUniversal 5V DC Power Cable USB to DC 5.5x2.1mm Charging Cable Cord Connector Plug Jack for Router Mini Fan Speaker Specification: Multi-Purpose Cable: USB to DC power cable with 7 interchangeable plugs connectors, which makes it fits most of home appliances. You do not have to worry about finding the suitable adapters when using various devices. High Quality: The USB to DC 5.5 x 2.1mm jack charging cable is made of durable material,and cable performance is good when connecting different preventing overvoltage or overcurrent. Extensive Compatibility: Universal USB to DC charging cable compatible with equipment,LED lights,digital fans,small [...]
46.20 $ Add to cartHot Sale 10 Pairs Medium Size Clear Silicone Replacement Ear Buds Tips For Sony Phillips 5 Pairs Medium Black 5 Pairs Silicone Feature: Product Description Inner diameter: around 4mm X Outside diameter:12mm High quality silicone earbuds, eartips, earpads, ear cushions Sound isolating design reduces ambient noise for high-intensity listening. It can also Re-usable and wash with water 5 Pairs Medium Black 5 Pairs Silicone Replacement Ear Buds Tips for Audio-Technica Skullcandy. for Monster Sony Ultimate Ears Sharp Sennheiser Plantronics TDK Phillips Panasonic Denon [...]
40.53 $ Add to cartmodel: B-04Input voltage: 5V 1-2AOutput voltage: 1.2V 250mA 1 x 4Product Certification: EU CE/EMC US FCC CertificationProduct features: regular 5V DC power supply, four slots independent charging, do not affect each otherPacking: bag packagingNet weight: 20gGross weight: 22gProduct size: 84 x 63 x 25mm/3.31 x 2.48 x 0.98inNotes:Please allow 1-3mm differs due to manual measurement.Due to the different display and different light, the picture may not show the actual color of the item. Thanks for your understanding. 1 X 4 Slots USB Battery Charger 1. Support CSV/EXCEL dropshipping . We offer discounts [...]
40.88 $ Add to cartAluminum Alloy Tether DSLR Camera Digital USB Cable Lock Clip Clamp Protector Features: This cable clamp is used to fix the cables when you are in tether shooting. It protect the socket of the camera and ensure it wouldn't been interrupted by cable loosening. This cable clamp is also used for DSLR video rigs, camera armor cage, follow focus. There are two groove in horizontal and perpendicular separately for cables. It is suitable for all most of DSLR Cameras. It comes with a 1/4inch thumb screw, it is used to install the cable clamp on cameras. There is a 1/4inch [...]
43.73 $ Add to cartColor: black / brown / brown The wrist strap is suitable for small digital cameras such as micro-single: Micro single: NEX-C3 NEX-5N NEX-7 NEX-6 NEX5R NEX5T, etc. The wrist strap is suitable for other brands of micro-cameras, such as: X10/X20, X100/X100S, J1/J2/J2, LX5/LX7, GX1/GX7, GF1/2/3/5/6, EM5, EP1/2/3, EPL3/5, EPM1/EPM2 Leica M/X1/X2/M9-P/S2-P and other cameras. parameter: Length of use: 19 cm The thinnest part width: 0.8cm Widest part width: 2.2cm Thickness: 3mm Material: high quality imported PU fabric, non-slip lining Using precision laser cutting and perforating processes to create a 100 flat section that is more precise and perfect. [...]
45.46 $ Add to cartChcę coś kupić ale szukam informacji jak zamówić... |
Kupiłem coś ale chcę poznać status zamówienia... |
Odebrałem paczkę ale mam pytanie lub problem... |
Chcę dokonać zwrotu i potrzebuję informacji... |
Droptech Sp. z o.o. droptech.polska@gmail.com |
ul. Łódzka 118, Piotrków Tryb. Sprzedajemy tylko przez internet |
NIP: 7712911090 REGON 386758083 |
Wysyłka bezpośrednio od producenta lub dostawcy |
DARMOWA WYSYŁKA + ubezpiecznie dostawy + śledzenie przesyłki |
CAŁKOWITY ZWROT podczas reklamacji |
Reviews
There are no reviews yet.